Leggings & activewear

Leggings photos that sell: how to photograph leggings with a phone

How to photograph leggings: lay them flat on a plain surface near a window, square the waistband at the top, keep the legs straight and slightly apart and shoot from directly above. Then add the back, the waistband, the pocket, a fabric close-up and a see-through test, because opacity is the first thing activewear buyers ask about.

Garmo teamUpdated 8 min read

Deep plum high-waisted leggings laid flat on a pale oak floor in window light, a hand holding a phone beside them ready to take the photogarmo result

What leggings photos have to show

A leggings listing has to answer five questions: the real colour, how high the waistband sits, the length, whether the fabric is see-through and how worn the pair is. On used leggings, wear shows in two places: pilling on the inner thighs and a stretched, wavy waistband. Buyers zoom straight to both.

Leggings are harder to photograph than jeans because they have no structure. Off the body they are two narrow tubes of fabric that curl, twist and shrink to half their worn width. A straight, evenly lit flat lay fixes most of that: it shows the cut, the seams and the length in one frame.

The method below is how to photograph leggings of any kind: full length, 7/8, cycling shorts and yoga pants. If you also sell denim, our guide to photographing jeans to sell covers rigid fabrics, washes and pockets. And once your flat lay is clean, Garmo can turn that flat lay photo into an on-model photo, which matters more for leggings than for almost any other garment.

Deep plum high-waisted leggings laid flat on a light grey sheet from above, waistband straight, legs parallel, side pocket visiblegarmo result
The cover photo: waistband square, legs straight, pocket and seams visible

How to lay leggings flat for a photo

This is the leggings flat lay setup we used for the photos in this guide. It takes about five minutes and needs a bed or a floor next to a window.

  1. 01

    Use a plain, matte surface

    A tightly pulled bedsheet, a light floor or a large sheet of card. Light grey works for dark leggings, mid-grey or wood for white and pastel ones. Avoid shiny surfaces: they bounce glare onto stretch fabric.

  2. 02

    Square the waistband first

    Lay the leggings face up and pull the waistband straight across the top at its full width. A rolled or twisted waistband hides the rise, and the rise is exactly what high-waist buyers are looking for.

  3. 03

    Straighten the legs

    Run both hands down each leg from hip to ankle. Keep the legs parallel with a gap of two or three fingers between them, so the inner seams and the crotch shape stay readable.

  4. 04

    Line up the seams

    Turn each leg until its inner seam runs straight along the inside. A twisted seam makes the whole pair look crooked, even when nothing is wrong with it.

  5. 05

    Shoot from directly above

    Stand over the leggings with the phone parallel to the surface, at 1× zoom. Fill about 80% of the frame and leave a margin, so marketplace crops do not cut off the ankles.

How to photograph leggings for resale: the 8-photo shot list

These eight photos answer the questions buyers otherwise send as messages. If your marketplace has fewer photo slots, keep 1, 2, 5 and 7. Shoot them in the same order every time so your listings look like one shop.

  • 1. Front flat lay

    The whole pair, waistband square, legs straight. This is the cover photo and the one Garmo uses to put the leggings on a model.

  • 2. Back flat lay

    Turn them over. Shows the back seams, a back pocket if there is one, and any shine on the seat from wear.

  • 3. Waistband

    Close on the waistband laid flat: its height, an inner key pocket, and whether there is a drawcord.

  • 4. Pockets

    Side pockets are a selling point. Open one slightly with a finger so buyers can see it takes a phone.

  • 5. Fabric close-up

    Phone parallel to the fabric, in daylight. Shows the texture: brushed, ribbed, shiny or matte.

  • 6. Inner thighs and gusset

    Where pilling and rubbing show first. One honest close-up prevents most returns.

  • 7. See-through test

    Fabric stretched in front of a window. Buyers trust this photo more than the word "squat-proof".

  • 8. Label and measurements

    Size label, fabric composition and the waist measured flat with a tape.

Are they see-through? How to show opacity in a photo

The see-through test is the photo that sells activewear. Stretch one leg over your hand, or between both hands, and hold it up in front of a bright window. If the fabric stays dark and no skin or light shows through, take the photo: it says more than any line in the description.

Stretch the fabric about as tight as it would be over a bent knee, because that is where thin leggings fail. Cheap or very worn leggings turn shiny and grey when stretched. If yours do, say so in the listing; a buyer who finds out at the gym leaves a worse review than one who was told.

Black leggings are the hardest to show. They look like a flat black shape in photos and hide both seams and pilling. Use a light surface and lift the exposure slightly, as explained step by step in our guide to photographing black clothing.

Two hands stretching deep plum leggings fabric taut in front of a bright window, the fabric staying fully opaquegarmo result
The see-through test: stretched in front of a window, no light comes through

Measurements, size and fit notes for leggings

Three measurements cover almost every question: waist (straight across the waistband, laid flat and unstretched), rise (from the crotch seam to the top of the waistband) and inseam (from the crotch seam to the ankle hem). Write them in the description and show the waist measurement in a photo.

Leggings sizes vary a lot between brands, so give the measurements even when the size label is clear. Add the fabric composition from the care label: a higher elastane share usually means more compression. Say whether the pair is high-rise or mid-rise, and full length or 7/8.

Be open about wear. Pilling on the inner thighs, a waistband that has lost its grip or a shiny seat are normal on used activewear. Buyers forgive wear they were shown; they do not forgive wear they discover after the parcel arrives.

Leggings flat lay vs. bed and hanger: good and bad photos

The same plum leggings, photographed four ways. The two good photos took five minutes longer than the two bad ones. Before you list, run your cover photo through the free listing photo checker for sharpness and exposure.

Works well

Good example: plum leggings flat on a light grey sheet, waistband straight, legs parallel and slightly apartgarmo result
Flat, waistband square, even lightColour, length, pocket and seams are all readable at thumbnail size.
Good example: close-up of the plum leggings' wide waistband, a finger opening the side phone pocket to show its depthgarmo result
Details in the same lightSame surface and window, so the gallery reads as one set.

Avoid

Bad example: the leggings crumpled on a navy floral duvet in yellow lamp light, one leg folded under, waistband rolled overgarmo result
Crumpled on the bed at nightLamp light turns plum into brown, and the floral duvet fights the fabric.
Bad example: the leggings folded over a thin wire hanger on a white door, hanging as a narrow shapeless stripgarmo result
Folded over a hangerWaistband and ankles hang at the same height: no length, no shape, no pocket.

Our test: leggings from a flat lay to a model

A flat lay shows the leggings; a worn photo shows the rise, the length on a body and how the fabric sits. That matters more for leggings than for most clothes, because they look completely different on. We put the front flat lay from this guide into Garmo Studio, chose Celine, one of the 42 stock models, and asked for three frames: a front view and a side view in the studio, and a walking shot on a street.

In all three frames the plum stayed the same plum, the waistband sat at the same height on the waist and the flatlock seams ran down the inner legs as in the flat lay. The side view showed what the front cannot: the phone pocket on the outer right thigh. Garmo paired the leggings with a plain white top and white sneakers, so nothing competes with them.

Knowing how to photograph leggings flat is what made this work: a straight, evenly lit flat lay gives the AI every detail to copy. To do the same with your own pair, use the tool to put pants and leggings on an AI model, and ask for a side view whenever there is a pocket. The first 3 images are free.

From leggings flat lay to on-model photos

The input was one phone photo on a bedsheet. Selling a matching set? Photograph the top and the leggings together and use the tool for a two-piece set on an AI model, so both pieces stay in one frame.

01

Plum high-waisted leggings with a side pocket

One flat lay, three frames with Celine. Colour, waistband height, pocket and seams carried over in every frame.

The original phone photo: plum high-waisted leggings flat on a light grey bedsheet, side pocket on the right thighYour photogarmo result
Your photo
Garmo result: Celine standing full length in the plum leggings, a white t-shirt and white sneakers in a light studiogarmo result
Celine · Studio, front
Garmo result: Celine in a three-quarter side view, hand on hip, the phone pocket on the right thigh of the plum leggings visiblegarmo result
Celine · Studio, side
Garmo result: Celine walking on a cobbled city street in the plum leggings, a white t-shirt and white sneakersgarmo result
Celine · Street

Questions about photographing leggings

How do you take pictures of leggings to sell?

Lay them flat on a plain surface near a window, square the waistband, keep the legs straight and slightly apart and shoot from directly above. Then add the back, the waistband, a pocket, a fabric close-up, a see-through test and the label with measurements.

Should leggings be photographed flat or on a hanger?

Flat. On a hanger, leggings fold in half or hang as a narrow strip, so buyers cannot judge the length or the rise. If you want a hanging photo, clip the waistband to a trouser hanger so both legs hang straight.

How do I show that leggings are not see-through?

Stretch the fabric over your hand or between both hands and hold it in front of a bright window. If no skin or light shows through, photograph it; buyers see it is opaque. Mention the result in the description as well.

How do I photograph black leggings?

Use a light grey surface and daylight, lift the exposure slightly and photograph the seams and waistband up close. Black fabric hides shape, so a worn photo, real or made with an AI model, helps buyers judge the fit.

How do I show how leggings fit without a model?

Give the waist, rise and inseam and say whether the pair is high-rise, full length or 7/8. A worn photo made from your flat lay with an AI model shows the rise and the length on a body at a glance.

Keep reading

All posts

Your next listing, shot this afternoon.

3 free images · no credit card · commercial rights included

Create 3 images free

Updated

3 images freeNo credit card Try it free